Description
Active, with activated penetration, makes short work of dirty concrete floors. Active penetrates through layers of grease, oil and dirt deep into the pores of concrete. As this penetration takes place, a chemical dissolving and loosening action attacks the soils, releases their hold, and floats them in the Active solution. Rinse Active off and the soils wash away with it. Even long-standing stains are removed. Old floors are restored, and with regular care, stay that way.
Active is powerful yet it is relatively mild, and does not contain caustic soda or acids. It is biodegradable, non-toxic and non-hazardous. Active is authorized by the USDA for use in federally inspected meat and poultry plants.
Usage
For heavy soils, Active may be applied to cement floors by first wetting the floor thoroughly, then sprinkling Active liberally over the surface. Allow to set a few minutes and agitate with a broom or scrub brush. Let stand about 15 minutes with occasional reagitation if needed, then rinse off with clean water and pressure. Active may be used for hand mopping or in regular commercial floor scrubbing machines. Add 6 ounces of Active in each gallon of hot water (120°F). Saturate floor surface. Work in with brush, broom or floor scrubber. Let stand several minutes. Rinse with clean water.
Safety Factors
Active contains sodium metasilicate. Avoid contact with skin and eyes. If contact should occur, rinse well with water. If irritation occurs, contact physician.
Safety Factors
Active contains sodium metasilicate. Avoid contact with skin and eyes. If contact should occur, rinse well with water. If irritation occurs, contact physician.
- #02000 | case of 4-8 lb pail
- #32000 | 45 lb pail
- #42000 | 125 lb drum
View Safety Data Sheet For This Product
NOTICE: The above information and recommendations concerning this product are based upon our laboratory tests and field use experience, however since conditions of actual use are beyond our control, any recommendations or suggestions are made without warranty, express or implied. Manufacturer’s and seller’s sole obligation shall be to replace that portion of the product shown to be defective. Neither shall be liable for any loss, damage or injury, direct or consequential, arising out of the use of this product.